Quick-Fit Bit Holder with 3/4" bit Fits Glastar G-8, Diamond Tech, Burk and other European style grinders.

Quick-Fit Bit Holder with 3/4" Bit

Bit Holder with 3/4" Standard Bit (Series 200).

TechniGlass's revolutionary new grinder bit system—More affordable than conventional bits that freeze-up, corrode and flake. These bits absorb, do not reflect vibrations for a smooth edge (no chips). Quickly interchangeable for desired jobs. Attractive and suitably packaged on color-coded cards. Fits Techniglass The Grinder, The Grinder 2 and The Grinder 3, as well as Glastar G-8, Diamond Tech, Burk and other European-style grinders.

HOW TO INSTALL REPLACEMENT BITS
The Quick-Fit Bit™ Holder slides down onto the grinder shaft. The Quick-Fit Bit® Grinding Sleeve must position to the bottom stop ring of the holder (extreme end of holder nearest to grinder reservoir floor). With the locking lever down, the perimeter of the Quick Fit Bit® Holder expands, locking the bit and holder into place.

HEIGHT ADJUSTMENT
To achieve full utilization of your grinding bit ensure that the sleeve is positioned at the BOTTOM stop ring of the holder (extreme end of the holder nearest to grinder reservoir floor). To adjust, flip the orange lever UP on the Quick-Fit Bit™ Holder. Slide HOLDER up to position desired. Lock in place by flipping the orange lever DOWN. DO NOT ADJUST SLEEVE ON HOLDER. THIS WILL CAUSE SLEEVE TO SLIDE UP HOLDER. Sleeve must remain at BOTTOM stop ring of the holder to operate properly.